![]() ![]() Do not install a new OCSM unless DTC B1650 cannot be cleared. For rail-type OCS systems, inspect the passenger side floorpan for damage and repair as necessary.When a vehicle has been involved in a collision and the Occupant Classification System Module (OCSM) has DTC B1650 stored in memory, the repair of the OCS system is to include the following procedures for the specified system: Refer to the appropriate workshop manual for OCS system removal and installation procedure. NOTE: After installation of new Occupant Classification Sensor (OCS) components, carry out the Occupant Classification Sensor (OCS) System Reset procedure as instructed in the workshop manual. Vehicles with Occupant Classification Sensor (OCS) systemĢ. DTCs must be cleared from all required modules after repairs are carried out. When any deployable device or combination of devices have deployed and/or the airbag control module (ACM/RCM) has DTC B1650 in memory, the repair of the vehicle SRS is to include the removal of all deployed devices and the installation of new deployable devices, the removal and installation of new impact sensors and the removal and installation of a new ACM/RCM. NOTE: Refer to the correct removal and installation procedure for all SRS components being installed. NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.ġ. NOTE: Always refer to the appropriate workshop manual procedures prior to carrying out vehicle repairs affecting the SRS and safety belt system. NOTE: Deployable devices (such as air bag modules, pretensioners) may deploy alone or in various combinations depending on the impact event. NOTE: After diagnosing or repairing a Supplemental Restraint System (SRS), the restraint system diagnostic tools (if required) must be removed before operating the vehicle over the road. Failure to follow this instruction may result in serious personal injury or death in a crash and possibly violate vehicle safety standards. If tools are not removed, the supplemental restraint system (SRS) device may not deploy in a crash. WARNING: Remove restraint system diagnostic tools from the vehicle prior to road testing. Inspection and Repair After a Supplemental Restraint System (SRS) Deployment ![]() No additional programming needed, when original module reset and put back in same vehicle.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |